Replacement terminal plate for bitzer, carrier, copeland, frascold

  A dirty term in our industry is “call back,” meaning a system that a technician just repaired is not working, and it becomes necessary to go back and   repair   the problem again. This is especially true after changing out a  compressor . Replacing a compressor is typically a major investment for a customer and a time-consuming job for a technician, so having to return and repair the same issue, or an additional issue, should be avoided. It is not possible to prevent all call backs, but here are some common   mistakes   to avoid. It is a good practice to check for an acidic refrigerant before and after replacing a compressor. If the refrigerant is found to be acidic, it will be necessary to clean up the system during the repair. Do not allow the new compressor to operate with a contaminated refrigerant. In addition, always replace the liquid line filter/drier during the repair. This helps to safeguard the system from circulating unwanted containments that...

  E-mail: annecompressorparts@aliyun.com WhatsApp No.: 0086 156 7008 2692 Semi-hermetic compressor terminals  are mainly used in commercial and industrial refrigeration. They carry large capacity and can continuously supply high energy. The terminals, which are small spare parts for the compressor, but they are required high performance to transfer high power constantly and stable. As a compressor part,  Terminals plate DB165A-102 fits for Bitzer Piston Compressor, the glass-to-metal sealing technology is a core process for high insulation resistance. Environmental friendly chemical nickel plating technology is applied on the surface treatment of semi-hermetic compressor terminals, the nickel plating is about 5-10μm thickness.  Production flow 1. Raw material arrives →2. Inspection→3. Steel needle etching→4. Oil removing on metal cap→5. Assembly and sintering→6. Airtightness inspection→7. Nickel plating→8. Welding→9. ...